Main Technical Parameters; Important - Hendi 210802 Mode D'emploi

1. MAIN TECHNICAL PARAMETERS

MODEL VOLTAGE
SUPPLIER
210802 230V/50Hz
210819 230V/50Hz
Short-term operation: 10 minutes operation.
2. INTRODUCTION
• We advise you to carefully read the instruction con-
tained in this package.
• If you wish to make the best use of the meat minc-
er and exploit all its possibilities, you must be
thoroughly familiar with its performance and op-
erating features.
• The meat mincer may only be used for mincing
fresh meat.
• Maintenance requires just a few simple operations
that may be carried out by the operator.
• To ensure a long life and minimize operating costs,
you should carefully follow the rules given in this
booklet.
• The manufacturer has designed the meat mincer
to ensure safe operating conditions:
Exclusion or removal of the safety features in-
stalled by the manufacturer will seriously under-
mine the guaranteed safety conditions.
• To ensure these conditions you must also fully
comply with the instructions regarding the instal-
lation and power supply of the meat mincer.
• The meat mincer must be installed in a work envi-
ronment free of corrosive agents.
• The installation site must not be subject to explo-
sion.
• The manufacturer company is not liable for any
POWER RPM
550W 170
750W 170
breakdown, accidents or faults caused by a failure
to observe ( or to apply ) the instructions contained
in this booklet. It is likewise not liable for any mod-
ifications, variations or the installation of accesso-
ries not previously authorized.
• Use only original SPARE PARTS.
• This instruction booklet is an integral part of the
meat mincer and must be kept in a safe place. The
features, information and drawings published in
this booklet are the exclusive property of the man-
ufacturer company.
• No part of this publication may be reproduced or
transmitted in any form.
ATTENTION! Do not continuously operate the ap-
pliance for too long to avoid overheating the mo-
tor. The continuous operation time must not ex-
ceed 10 minutes. Let the appliance cool down if the
appliance housing becomes too hot. Only operate
the appliance again, after it has cooled.
IMPORTANT: Before connecting your units to the
power supply, be sure the machine's electrical
specifications, printed in the unit's nameplate,
match those of your local power.
• For first-time use, remove the mincer head and
wash all parts thoroughly.
A B
(LENGTH, MM) (WIDTH, MM)
432 261
427 261
C
(HEIGHT, MM)
484
486
EN
5