Setting Up Two Bases - Ergomotion 390 Série Mode D'emploi

setting up two bases

If any split setup is being installed, plastic connecting straps are provided (one per base) to se-
cure the bases together. Use both straps to secure the head and foot portions together.
STEP 1
With the bases in their
desired location, slightly
loosen both legs to allow
the strap to fit on the leg
bolt, between the leg
washer and frame .
14
STEP 2
Slide side (a) of the connecting strap onto leg bolt . Swing the strap
and connect side (b) to the leg bolt . Secure the strap by shifting to
the left .
a
STEP 3
Re-tighten legs . Do not over tighten . Use the remaining strap and
repeat on other end of the base .
b