Addition Of Distances - Powerfix Profi HG02404 Instructions D'utilisation Et Consignes De Sécurité

stand between the marked lines.
(see Fig. F).
2. Press the READ button
ured distance will be appeared on
the display
When you hold the READ button
pressed down and slowly move the
product over the surface to be meas-
ured, the product will continuously
measure the distances. Measured val-
ues will be shown on the display

Addition of distances

With the product you can add the
measured distances together:
1. Measure the first distance as described
in the section "Steps to do distance
measurement".
2. Press the + / = button
sage "+" appears in the display
and the measured distance in the
row below.
3. Measure the next distance. The new
distance measured is shown in the
upper row of the display.
4. Press the + / = button again. The new
measurement is added to the old in
the lower row.
5. Repeat steps 3 to 4 to add further
measurements.
6. Press the MODE button
the addition mode. All the measure-
ments will be deleted.
16 GB/IE/NI
.
2
12
. The meas-
6
6
2
. The mes-
2
to leave
4
.