SilverCrest SEMM 1470 A1 Mode D'emploi page 24

12) Switch the appliance off using the on/off switch
13) Clean the appliance as described in the section "Cleaning and Care".
NOTE
► If you do not turn off the appliance with the on/off switch
will switch itself into power saving mode automatically after approx. 15
minutes if no other button is pushed. If you want to make another drink,
simply press any button. The appliance heats back up.
Changing the duration of the milk froth output
NOTE
► You can adjust the amount of the milk froth by turning the "Milk quantity"
knob
"Milk quantity" knob
out of the milk nozzle
do not turn the "Milk quantity" knob
Otherwise you will be in cleaning mode (see section "Cleaning and care").
You can customise the duration of the milk froth output for the programmes
"Small latte" and "Large latte".
"Small" latte
–
Press and hold the "Small" latte button
the pump starts to work. Milk froth comes out of the milk nozzle.
–
Once the desired quantity of milk froth has been produced, stop milk
froth production by pressing the "Small" latte button
can set a duration of 5–70 seconds.
–
Following the milk froth production, the espresso comes out of the
espresso outlet
–
The next time you prepare a latte macchiato using the "Small" latte but-
ton
SEMM 1470 A1
and also the duration of the milk output. The further you turn the
toward "
during the same amount of time. Make sure you
to prepare the latte macchiato.
the newly programmed duration will be used for milk output.
.
" the more milk/milk froth will come
further than the "
for about 3 seconds until
GB │ IE │ NI
, the appliance
" marking.
again. You
│ 21 ■