Whirlpool HYBRIDCARE Instructions D'installation page 17

ALL DOORS:
2.
Remove door from dryer
IMPORTANT: If the protective film has not yet been removed
from the dryer, peel the film from the dryer door before
proceeding.
Using a T25 screwdriver, remove the four screws securing
®
the door hinge to the dryer and lift the door up and out to
remove. Place the door on a soft towel or other non-scratch
surface.
3.
Move the door strike
Using a T25 ® screwdriver, remove the two screws securing
the door strike to the door frame of the dryer. Rotate the strike
180° and attach to the opposite side of dryer door frame with
the two screws removed earlier, as shown.
4.
Remove inner door from outer door
Top of
door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door.
5.
Remove hinge
Using a T20 screwdriver, remove the six screws holding the
®
hinge assembly in place.
Hinge
17