Electrical Installation; Voltage Checks; Electrical Wiring; Bonding And Grounding - Zodiac Jandy Pro Serie VS FloPro Manuel D'installation Et De Fonctionnement

Jandy Pro Series VS FloPro
®
3.2

Electrical installation

3.2.1

Voltage Checks

The correct voltage, as specified on the pump data plate and
the specification chart on page 26, is necessary for proper
performance and long motor life. Incorrect voltage will
decrease the pump's ability to perform and could cause
overheating, reduce the motor life, and result in higher
electric bills.
It is the responsibility of the electrical installer to provide
data plate operating voltage to the pump by ensuring proper
circuit sizes and wire sizes for this specific application.
The National Electrical Code (NEC, NFPA-70)requires
all pool pump circuits be protected with a Ground Fault
Interrupter (GFCI). Therefore, it is also the responsibility
of the electrical installer to ensure that the pump circuit
is in compliance with this and all other applicable
requirements of the National Electrical Code (NEC) and
any other applicable installation codes.
CaUTion
Failure to provide data plate voltage (within 10%)
during operation will cause the motor to overheat and
void the warranty.
3.2.2

Bonding and grounding

1. The motor frame must be bonded to a reliable
grounding point using a solid copper conductor,
No. 8 AWG or larger. The motor frame must
be bonded to all metal parts of the swimming
pool, spa, or hot tub structure and to all electrical
equipment, metal conduit, and metal piping
within five (5) feet (15 cm) of the inside walls of
the swimming pool, spa, or hot tub.
noTE
In Canada, the pump must be located a minimum of
three (3) meters (approximately 10 feet) from the water
(CSA C22.1).
2. Bond the motor using the provided external lug.
See Figure 8.
Warning
Always disconnect the power source before working on
a motor or its connected load.
Warning
Make sure that the control switch, time clock, or control
system is installed in an accessible location, so that in
the event of an equipment failure or a loose plumbing
fitting, the equipment can be turned off. This location
must not be in the same area as the pool pump, filter,
and other equipment.
|
Variable-Speed Pump Installation & Operation Manual
™
CaUTion
The pump must be permanently connected to a
dedicated electrical circuit. no other equipment,
lights, appliances, or outlets may be connected to
the pump circuit, with the exception of devices that
may be required to operate simultaneously with the
pump, such as a chlorinating device or heater.
3.2.3

Electrical Wiring

1. The pump motor must be securely and
adequately grounded using the green screw
provided. Ground before attempting to connect
to an electrical power supply. Do not ground to a
gas supply line.
2. Wire size must be adequate to minimize voltage
drop during the start-up and operation of the
pump. See Table 3 for suggested wire sizes.
3. Insulate all connections carefully to prevent
grounding or short-circuits. Sharp edges on
terminals require extra protection. For safety,
and to prevent entry of contaminants, reinstall all
conduit and terminal box covers. Do not force
connections into the conduit box.
noTE
Since the pump is operated by either a variable speed
controller (JEP-R), an AquaLink
AquaLink Pool Digital Assistant (PDA), the pump will
not be turned on until it is turned on with one of these
controllers.
Breaker Panel
GROUND
Circuit
Breaker
Figure 8. Bonding the Motor
Page 11
English
RS controller, or an
®
Bonding Lug
Terminal Block
Variable-Speed
Pump (230 VAC)