Section 1. Important Safety Instructions; Safety Instructions - Zodiac Jandy Pro Serie VS FloPro Manuel D'installation Et De Fonctionnement

Page 4
English

section 1. important safety instructions

1.1

safety instructions

All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes.
When installing and using this electrical equipment, basic safety precautions should always be followed, including the
following:
risK oF sUCTion EnTrapMEnT haZard, WhiCh, iF noT aVoidEd, Can rEsUlT in sErioUs inJUrY
or dEaTh. Do not block pump suction, as this can cause severe injury or death. Do not use this pump for
wading pools, shallow pools, or spas containing bottom drains, unless the pump is connected to at least two
(2) functioning suction outlets. Drain covers must be certified to the latest published edition of ANSI/ASME
A112.19.8.
To reduce the risk of injury, do not permit children to use this product.
To reduce the risk of property damage or injury, do not attempt to change the backwash (multiport, slide, or full
flow) valve position with the pump running.
Jandy Pro Series pumps are powered by a high voltage electric motor and must be installed by a licensed or
certified electrician or a qualified swimming pool service technician.
Due to the potential risk of fire, electric shock, or injuries to persons, Jandy Pro Series pumps must be installed
in accordance with the National Electrical Code (NEC), all local electrical and safety codes, and the Occupational
Safety and Health Act (OSHA). Copies of the NEC may be ordered from the National Fire Protection Association,
470 Atlantic Ave., Boston, MA 02210, or from your local government inspection agency.
risK oF ElECTriC shoCK, FirE, pErsonal inJUrY, or dEaTh. Connect only to a branch circuit that is
protected by a ground-fault circuit-interrupter (GFCI). Contact a qualified electrician if you cannot verify that the
circuit is protected by a GFCI. Make sure such a GFCI should be provided by the installer and should be tested
on a routine basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset
button. Power should be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI
interrupts power to the pump without the test button being pushed, a ground current is flowing, indicating the
possibility of electrical shock. Do not use the device. Disconnect the device and have the problem corrected by a
qualified service representative before using.
Incorrectly installed equipment may fail, causing severe injury or property damage.
Jandy Pro Series VS FloPro
®
rEad and FolloW all insTrUCTions
Warning
Warning
Warning
Warning
Warning
Warning
Warning
|
Variable-Speed Pump Installation & Operation Manual
™