Spinlock XX Clutch XX0812 Mode D'emploi page 10

ZS–RLB Remote Lockback Switch
For use with ZS1214, ZS1618, ZS1014C, ZS1618C, ZS1014B and ZS1618B Jammers or existing
halyard locks. Allows the ZS Jaws to be pre-tensioned for release.
1. Mount the ZS-RLB in it's preferred location using M5 fasteners.
2. Choose a suitable very low stretch control line 2-4mm which can be spliced.
2. Attach the control line to the jaw set using a thumb knot or similar - see diagram below.
Remove rear block and jaw step ( see page 22).
3. Thread the control line through the spring and rear blockand fasten the rear block into place.
4. With the control line cut to approximately the correct length, splice the control line to the eye
of the RLB-Spring using an adjustable splice.
18
www.spinlock.co.uk
5. Ensure the control line has a free, un-interrupted, low friction run to the jammer. If necessary
use bulls eyes or blocks to ensure a smooth run.
6. With the jaw set loaded on the correct diameter line and the RLB closed, adjust the control line
splice so it is just taut.
7. Check operation as described (see page 12 and 13). Some adjustment may be necessary
before making the splice permanent.
8. Changes in the rig set-up or line diameter will require the control line splice to be adjusted.
Open
Closed
ZS-RLB
how to use spares
19
pages 12-13 pages 34-35