Setting the heating output
♦
Activate the appliance by selecting the heat level. To do this, press the func-
tion selector
♦
To put the appliance into standby mode, press the function selector button
or
seconds of overrun time, the display backlight turns off .
Selecting the temperature
Using the "Increase temperature" button
ture
you can set the target temperature
The selected target temperature
The room temperature
NOTE
►
As soon as the room temperature has reached the target temperature, the
heater switches off . The ventilator continues to run. If the room temperature
falls below the target temperature, the heater is reactivated automatically.
Setting the timer
The appliance has a timer that you can use to set the desired heating duration.
Once the period is over, the appliance switches off automatically.
♦
Press the "H" button
♦
Press the "M" button
NOTE
►
If you keep the buttons on the appliance pressed, the values keep increasing
until you release them. The selected time is shown on the display
Swivel function
The appliance has a swivel function. This will cause the appliance to swivel back
and forth so that the warm air is more evenly distributed throughout the room.
♦
Switch the swivel function on by pressing the button for the swivel function
or
♦
Switch off the swivel function by pressing the button for the swivel function
or
SHLF 2000 B1
or
until the desired heat level is shown in the display
12
25
Low heat output: appliance produces an output of 1000 watts
High heat output: appliance produces an output of 2000 watts
until the display
shows only the room temperature
25
11
to a maximum 38°C. Using the "Decrease temperature" button
is measured by the temperature sensor
or
17
or
16
.
22
again.
22
or
you can set the target tempera-
13
21
to a minimum 6°C.
is shown on the display
to set the hours.
27
to set the minutes.
26
:
11
12
. After a few
or
14
23
.
11
9
.
.
11
18
18
13
GB
IE