Battery Installation - Omegon Night Eye 3x42 Mode D'emploi

Clean optical parts (lenses) with professional lens cleaning supplies designed for use
with multicoated optics.
Clean the exterior of your Night Eye 3x42 with a soft, clean cloth.
Damage to this device from failure to observe these warnings may void the Night Eye's
warranty!

BATTERY INSTALLATION

To install, unscrew the battery compartment cover , insert the battery (CR123A) into the
battery compartment so that the positive (+) and negative (-) terminals of the battery
match the markings inside the compartment, replace the battery cover carefully. Do not
over tighten.
USING THE NIGHT SPY
After installing the battery the Night Eye is ready for use. Please keep the following
points in mind:
Move into a dark area before activating the Night Eye 3x42 light amplifier.
Remove the lens cap and store in pocket provided. Activate the device by pushing the
"ON" button.
If the subject to be viewed is in a complete dark area, including lowlight shadow areas,
activate the infrared illuminator by pressing the "IR" Button.
Direct your Night Eye 3x42 device at an object at a distance approximately 100 yds.
Adjust the eyepiece and objective lens diopter setting to focus the unit by rotating the
eyepiece and objective lens. After the adjustment, do not rotate the eyepiece irrespective
of the distance and other conditions.
Direct your Night Eye 3x42 device at the subject to be viewed and adjust the final focus
by rotating the objective lens focusing ring until the image quality is optimal.
The green LED indicates that the light amplifier unit is on. The red LED indicates that the
IR illuminator is on. Do not store your Night Eye 3x42 when any of the indicators are lit.