Using The Device - Thermor Riva 2 Notice D'installation Et D'utilisation

Description of the control panel
1
Winter use with the boiler lit
Heating your room
- Increase or decrease the flow through the supply valve d, depending on the desired temperature (in
the case of a thermostatic valve).
Use of Turbo mode
- Press switch , indicator light
- Set knob to
- Set Turbo mode's duration by turning knob
- Press the same knob
The fan operates for the selected period.
Use on electricity for versions:
- All electric with or without fan.
- Mixed with fan in SUMMER position.
Setting the CONFORT temperature
It is the temperature desired when the room is occupied.
a) Set the switch to
b) Align the toothed screw
rature is less than desired.
Wait a few hours for the temperature to stabilise.
If the temperature setting does not suit you, adjust it using the adjusting screw
by-step using the notches (one notch at a time).
The thermostat's cycle takes several minutes. It is possible that the heating indicator may not react
instantaneously, but instead only on the next thermostat cycle.
U
SING THE DEVICE
2
7
6
5
illuminates.
.
to start the Turbo. The "Turbo ON"
to the ON position, the
with the marking
Temperature setting knob with Hors Gel
position and ability to restrict the range.
Time adjustment knob TURBO
1/4h, 1/2h, 1h, 2h.
3
Power On indicator
4
TURBO indicator
TURBO control
Heating ON/OFF switch
Heating indicator
.
indicator lights.
: the indicator light
20
light illuminates.
illuminates if the tempe-
. Proceed step-