Anker PowerCore 20100 Nintendo Switch Edition Manuel De L'utilisateur page 3

EN
Check your device's battery indicator for charging progress.
LED will remain lit while your device is charging.
When charging USB-C PD (Power Delivery) devices like Nintendo Switch™, connect the
cable to the USB PD port.
When charging other devices, connect the cable to the USB-A port.
After connecting the cable, charging will begin automatically. If not, press the button on
the side of PowerCore, wait for 10 seconds, then reconnect the cable.
When temperatures exceed 140°F / 60°C, all 4 LEDs will flash for 10 seconds. To prevent
risk of damage, the USB-A port's output will automatically shut off. USB-A functionality
will return when temperatures fall below 140°F / 60°C.
To stop charging, press the button on the side of PowerCore twice in rapid succession. To
02
begin charging again, press the button once.
3. Recharge your PowerCore
EN
03