Turning The Appliance Off - Bertos G6F2BH6 Mode D'emploi

Ovens FGP
OPERATING INSTRUCTIONS FOR ELECTRIC OVEN
Turn-on and turn-off of the FE type electric oven (fig. 6)
By turning the selector switch (23) to the left or the right,
you can choose the type of cooking, heat above and/
or below. In either of these positions the green light
comes on (25 = live appliance). By turning the selector
switch (24) on desidered position, resistances are switched
on warning light (26) comes on and goes off when
the selected temperature is reached and the resistances
switch off. To turn the oven off, turn the thermostat into
position and the selector into position
Turn-on and turn-off of the FE1 type electric oven
(fig. 8)
In this type of oven the heat comes from the rear of
the chamber; it is, however, equipped with a fan which
MOD. N°: MOD.
distributes the heat evenly throughout the oven chamber.
Qn
V kW: Hz: 50/60 IPX2 V
By turning the selector switch (24) on desidered position,
resistance is switched on warning light (26) comes on and
goes off when the selected temperature is reached and
the resistance switch off. To turn off the oven, turn the
thermostat to the off position
The first position of the knob corresponds to the fan
operation for cooling – defrosting.

TURNING THE APPLIANCE OFF

MOD. N°:
Turning the appliance off in an emergency
Qn
V kW: Hz: 50/60
In case of malfunctioning, disconnect the gas and electric
power supplies from the appliances.
Position Degrees °C
1 60
2 100
3 140
4 180
5 220
6 260
7 300
N°:
Qn
kW: Hz: 50/60 IPX2
.
IPX2
What to do in the case of malfunctioning or if the
appliance is not to be used for a long period
When the appliance is not to be used for a long time,
clean thoroughly and turn off both the gas and electric
supply. In the case of malfunctioning or failure, turn off
the gas supply and disconnect from the mains. Call the
service centre.
ATTENTION!
- Before cleaning, turn the machine off and let it cool.
- For electrically powered machines, turn off the
disconnecting switch to cut off the supply of
electricity.
Careful daily cleaning of the machine ensures perfect
operation and long life.
The steel surfaces are to be cleaned with liquid dishwashing
detergent diluted in very hot water, using a soft cloth. For
tougher dirt, use ethyl alcohol, acetone or another non-
halogen solvent.
.
Do not use abrasive powder detergents or corrosive
substances such as hydrochloric, muriatic, or sulphuric
acid. The use of acid may compromise operation and
safety of the machine.
Do not use brushes or pads made of metal or alloys which
may cause rust stains. For the same reason, avoid contact
with iron objects.
Use caution with stainless steel pads and brushes which,
although they do not contaminate the surfaces, may
cause harmful scratches.
If the dirt is stubborn, absolutely do not use sandpaper
or grinding paper. We suggest using synthetic sponges
instead, such as Scotch-Brite).
Also, do not use products for cleaning silver. Beware of the
fumes of hydrochloric sulphuric acid used, for example, to
clean floors. Do not aim jets of water at the machine, to
avoid damaging it.
After cleaning, rinse thoroughly with clean water and dry
carefully with a cloth.
CARE OF THE MACHINE
| 113
EN