Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
disk. This will cause a risk of crushing.
•
The chain becomes hot during grind-
ing. Do not touch the machined loca-
tion, as there is a risk of being burnt.
•
Use only grinding disks recommended
by the manufacturer. Do not use saw
blades.
•
Switch off the device and disconnect at
the plug
- to release a jammed insertion tool,
- if the connecting cable is damaged
or tangled,
- in the case of unusual noises.
Installation
Always use the M10x70 screws
from the package to mount the unit.
Make sure to leave enough
room for working and that
nobody else is put at risk.
Always use screws of suf-
ficient length and thickness
to mount the device on the
work surface, in order to
prevent loss of control of the
device.
Installing the appliance:
-
Thickness of the table edge:
15 - 30 mm.
-
Drill diameter: 10.5 mm.
-
Size of screw: M10
1. Use the stop notches (9) to cor-
rectly place the appliance on the
worktop (22). Make sure that the
grinding plinth (8) protrudes be-
yond the edge of the table.
2. Use a pen to mark the drill holes
and remove the appliance.
40
3. Drill two holes into the worktop
(22).
4. Using the enclosed screws (23),
washers and nuts (24), screw the
grinding plinth in place on the
worktop.
Assembling the grinder:
5. Screw the handle (4) into the
grinding head (2).
6. Remove the locking screw (10)
from the chain clamping unit (12).
7. Place the chain clamping unit (12)
on the grinding plinth (8) and fix it
using the locking screw (10).
8. Snap the mains lead (17) into the
cable hook (16).
Screwing on the adjusting
screw:
9. Place the enclosed washer (25) on
the adjusting screw (6).
10. Screw the adjusting screw (6) onto
the securing nut (26) fixed into the
grinding head (2).
Operation
Working with the equipment
Caution! Risk of injury!
- Use only grinding disks and acces-
sories recommended by the manu-
facturer. The use of other insertion
tools and other accessories may
cause risk of injury.
- Never operate the device without
the visual protection disk.
- Do not use saw blades.
- Check the grinding disk before
use: check the distance between
the protective screen and the grind-
ing disk.
- Do not use broken, cracked or oth-
Publicité
Chapitres
Table des Matières
