FLORABEST FSG 85 B1 Traduction Du Mode D'emploi D'origine page 38

GB
- Do not use tools in the presence of
flammable liquids or gases.
Power tools create sparks which may
ignite the dust or fumes.
Guard against electric shock.
•
Avoid body contact with earthed or
grounded surfaces (e.g. pipes, radia-
tors, ranges, refrigerators).
Keep other persons away.
•
Do not let persons, especially children,
not involved in the work touch the tool
or the extension cord and keep them
away from the work area.
Store idle tools. When not in use,
•
tools should be stored in a dry locked-
up place, out of reach of children.
Do not force the tool. It will do
•
the job better and safer at the rate for
which it was intended.
Use the right tool.
•
- Do not force small tools to do the job
of a heavy duty tool.
- Do not use tools for purposes not
intended; for example do not use cir-
cular saws to cut tree limbs or logs.
Use of the power tool for operations dif-
ferent from those intended could result in
a hazardous situation.
Dress properly.
•
- Do not wear loose clothing or jewel-
lery, they can be caught in moving
parts.
- Anti-slip footwear is recommended
when working outdoors.
- Wear protective hair covering to con-
tain long hair.
Use protective equipment.
•
- Use safety glasses.
- Use face or dust mask if working op-
erations create dust.
Connect dust extraction equip-
•
ment. If the tool is provided for the
connection of dust extraction and col-
lecting equipment, ensure these are
38
connected and properly used.
Do not abuse the cord. Never
•
yank the cord do disconnect it from the
socket. Keep the cord away from heat,
oil and sham edges.
Secure work. Where possible use
•
clamps or a vice to hold the work. It is
safer than using your hand.
Do not overreach. Keep proper
•
footing and balance at all times.
This enables better control of the power
tool in unexpected situations.
Maintain tools with care.
•
Many accidents are caused by poorly
maintained power tools.
- Keep cutting tools sharp and clean
for better and safer performance.
- Follow instruction for lubricating and
changing accessories.
- Inspect tool cords periodically and if
damaged have them repaired by an
authorized service facility.
- Inspect extension cords periodically
and replace if damaged.
- Keep handles dry, clean and free
from oil and grease.
Disconnect tools. When not in use,
•
before servicing and when changing
accessories disconnect tools from the
power supply.
Such preventive safety measures reduce
the risk of starting the power tool acci-
dentaIly.
Remove adjusting keys and
•
wrenches. Form the habit of check-
ing to see that keys and adjusting
wrenches are removed from the tool
before turning it on.
A wrench or a key left attached to a ro-
tating part of the power tool may result
in personal injury.
Avoid unintentional starting.
•
Ensure switch is in "off" position when
plugging in.