Further Safety Instructions - FLORABEST FSG 85 B1 Traduction Du Mode D'emploi D'origine

Use outdoor extension leads.
•
When the tool is used outdoors, use
only extension cords intended for out-
door use and so marked.
Stay alert, watch what you are
•
doing and use common sense
when operating a power tool.
Do not use a power tool while you are
tired or under the influence of drugs,
alcohol or medication. A moment of
inattention white operating power tools
may result in serious personal injury.
Check damaged parts. This will
•
ensure that the safety of the power tool
is maintained.
- Before further use of tool, it should be
carefully checked to determine that it
will operate properly and perform its
intended function.
- Check for alignment of moving parts,
binding of moving parts, breakage of
parts, mounting and any other condi-
tions that may affect its operation.
- A guard or other part that is dam-
aged should be properly repaired or
replaced by an authorized service
centre unless otherwise indicated in
this instruction manual.
- Have defective switches replaced by
an authorized service centre.
- Do not use the tool if the switch does
not turn it on and off.
There is a risk of injury.
Warning.
•
The use of any accessory or attach-
ment other than one recommended in
this instruction manual may present a
risk of personal injury.
Have your tool repaired by a
•
qualified person. This electric tool
complies with the relevant safety rules.
Repairs should only be carried out by
qualified persons using original spare
parts, otherwise this may result in con-
siderable danger to the user.
• If the supply cord of this power tool
is damaged, it must be replaced by
a specially prepared cord available
through the service organization.

Further Safety Instructions

• Connect the device only to a power
point with a residual current protective
device (RCD) with a measured residual
current of not more than 30 mA.
• Keep the mains cable and extension
cable away from the grinding disk and
saw chain. In the event that it is dam-
aged or severed, immediately discon-
nect the plug from the socket.
Do not touch the cable before it has
been disconnected from the mains.
Risk of electric shock.
• Before use, carry out a visual inspec-
tion of the grinding disk. Do not
use grinding disks that are spalled,
cracked or otherwise damaged. Re-
place a worn grinding disk.
• Never operate the device without the
visual protection disk.
• Do not work with the device if you
are tired or after the consumption of
alcohol or tablets. Always take a break
from the work in good time.
• Do not use the device in an explosive
atmosphere or where sparks could
cause fire, explosion etc. Failure to ob-
serve this will result in a risk of fire or
explosion.
• Keep your hands away from the grind-
ing disk and chain teeth when the
device is in use. Do not move the chain
by hand. This will cause a risk of in-
jury.
• Never place your fingers between the
grinding disk and rotary disk or be-
tween the grinding disk and protection
GB
39