Pairing A Bluetooth Device - Alesis TransActive Wireless Guide D'utilisation

TROUBLESHOOTING
If the sound is distorted: Try lowering the volume control of your sound source or musical instrument. Also, try to
reduce the overall volume of TransActive Wireless.
If there is too much bass: Try adjusting the tone or EQ control on your sound source to lower the bass level. This
will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using microphones: This is probably feedback. Point the
microphones away from the speaker.
If you can't hear the microphone over the music volume: Turn down the music volume from your source.

PAIRING A BLUETOOTH DEVICE

1. Turn on your Bluetooth device.
2. Power on TransActive Wireless and it will automatically go into pairing mode to search for Bluetooth devices.
You will know you are in pairing mode when the LED is blank.
3. If your Bluetooth device is not able to pair to TransActive Wireless, press the disconnect button on TransActive
Wireless to break previous Bluetooth connections and reset the Bluetooth module.
4. Navigate to your Bluetooth device's setup screen, find "Alesis TransAct" and connect.
Note: If your Bluetooth device prompts for a pairing code, enter '0000'.
5. TransActive Wireless LED will light up solid when it is 'paired'.
Note: Users should consider updating their OS if experiencing trouble with pairing or playing music.
6. To disconnect pairing, press the 'Disconnect' button on TransActive Wireless.
7. To connect to another Bluetooth device, repeat steps 3-4.
Note: Maximum range will be achieved when using devices with Bluetooth 4.0.
5