Abicor Binzel ABITIG GRIP Serie Mode D'emploi page 16

4 Putting into operation
1
5
1 Torch body
2 Gas nozzle
Fig. 1 Step 1-4
4.2 Shortening the tungsten electrode
4.3 Connecting the cable assembly
EN - 6
Equip the torch neck according to the following figure:
Step 1
4
3 Tungsten electrodes
4 Back cap
NOTE
• Instead of the electrode holder, you may also use a gas diffuser. Due to
its design, it will produce a laminar gas flow.
The electrode type is set by EN ISO 6848. The maximum electrode length
depends on the torch type.
NOTE
• The welding performance is affected by the selection of the tungsten
electrode and by wear. A smooth, groove-free sharpened end of the
tungsten electrode has a positive effect on the welding result.
1 Plug the hose assembly connection into the power source and secure it with
a connection nut.
2 Properly mount the connections for water supply/return, shielding gas and
control line plug.
Step 2-3
3
5
TIG welding torch
Step 4
2
Electrode holder