Functions; Water Drainage - Domo DO190A Mode D'emploi

DO190A

FUNCTIONS

Cooling function :
Make sure the exhaust hose is proparly instaled. When you want to cool you always
have to guide the hose through a window to the outside, to remove the hot air from the
room.
Press the mode button a few time until the cool function is activated. Press the
temperature button a few times to select the disired temperature.
Press the ventilation speed button to select the desired ventilation speed. There are
three speeds : slow, medium or fast.
To make the cooling optimal, take note of the following :
When the room is in direct contact with the sun, close the curtains.
Never place the appliance near a heating source.
Dehumidifi cation function :
Keep doors and windows closed to enlarge the effect of dehumidifi cation.
Make sure the drip tank is well in place.
Press the mode button a few times to select the dehumidifi cation function. The speed
of dehumidifi cation can not be changed.
When you only use the appliance to dehumidify you don't need to use the exhaust
hose.
Ventilation function :
Press the mode button a few times to start the ventilation function. On the display is
shown a fan symbol. Press the ventilation speed button to determine the ventilation
speed.
CONNECTING THE EXHAUST HOSE
Place the rectangular piece of the exhaust hose on the air outlet of the appliance.
Place the other end through a nearby window. Attention : the length of the hose must
be between 0.5 m and 1.5 m.
When you place the exhaust hose on the appliance, try to keep the hose horizontaly.
The hight of the opening through which you guide the exhause hose can vary from 40
cm upto 130 cm.

WATER DRAINAGE

When the airconditioner is working in the cool mode or dehumidifi cation mode the
condensation water will be drained into the internal drip tank. When the tank is full
this will be indicated on the display en a buzzing sound will be heard. On the display
is shown the code "E4". After three minutes the appliance will turn off.
Place the water plate underneath the drainage hole. Remove the plug and knop from
the drainage.