Berner BCLL BASIC Manuel D'utilisation Et De Sécurité page 18

ENGLISH
Setting up the Tool (fi g. C1 - C4)
The tool facilitates various set-ups, making it useful for several applications.
FLOOR SET-UP
• Place the tool on a relatively smooth and level surface.
WALL SET-UP (FIG. C1)
The keyhole (13) in the pivot bracket (8) is used for mounting to wall
constructions.
Alternatively, the tool can be attached to metal studs directly using the
magnets (14).
• Drive a screw or nail into the wall.
• Hang the tool onto the fastener by the keyhole.
FITTING THE TOOL TO THE WALL MOUNT (FIG. C2 - C4)
The tool has been equipped with a wall mount (9) for mounting to wall track
to aid in drop ceiling installation and other specialty leveling projects. The
pivot bracket (8) has magnets to attach the tool to the wall mount.
• Align the magnets (14) with the metal plate on the wall mount (9).
• To remove the wall mount, pull the wall mount from the tool applying
suffi cient force.
To fi t the wall mount to wall track, proceed as follows:
• Open the clamp jaws (15).
• Place the clamp jaw around the wall track and release the clamp to
close the clamp jaws shut on the track.
To mount the wall mount to a wall, proceed as follows:
• Hold the tool at the desired position against the wall and mark the
location of the mounting hole on the wall.
• Drill a hole at the marked location.
• Insert a corresponding plug into the hole.
• Hold the tool in front of the plug.
• Turn a screw into the mounting hole (16).
Adjusting the Tool
• To initiate the leveling procedure, switch on the tool. The level and/
or plumb orientation is correctly adjusted as long as the laser beams
remain on.
16