Assembly And Adjustment - Berner BCLL BASIC Manuel D'utilisation Et De Sécurité

The warnings should read as follows:
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
• If the warnings are in a foreign language, proceed as follows:
– Remove the required label from the sheet.
– Carefully place the label over the existing label.
– Press the label in place.

ASSEMBLY AND ADJUSTMENT

WARNING! Do not place the laser in a position which
may cause anyone to intentionally or unintentionally
stare into the laser beam. Serious eye injury may result
from staring at the beam.
Replacing Batteries (fi g. B)
The attachment uses batteries of type LR6 (AA).
• Open the battery compartment cover (10).
• Replace the batteries (12). Make sure the new batteries are placed as
indicated.
• Close the battery compartment cover.
WARNING: When replacing batteries, always replace
the complete set. Do not mix old batteries with new ones.
Preferably use alkaline batteries.
LOW BATTERY INDICATOR (FIG. A)
The tool has been equipped with a low battery indicator (3) located on the
control panel. The low battery indicator is lit while the tool is switched on. It
will blink to indicate that the batteries need to be replaced and the tool will
automatically shut down.
• Switch off the tool and remove the batteries as soon as the indicator
blinks.
ENGLISH
15