Philips HP4684 Mode D'emploi page 7

- Check the condition of the mains cord regularly. Do not use the
appliance if the plug, the mains cord or the appliance itself is damaged.
- If the mains cord is damaged, you must have it replaced by Philips, a
service centre authorised by Philips or similarly qualiied persons in
order to avoid a hazard.
- This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
- Children should be supervised to ensure that they do not play with
the appliance.
- Keep the appliance away from non-heat-resistant surfaces and never
cover the appliance with anything (e.g. a towel or clothing) when it is
hot.
Keep the appliance away from lammable items.
-
- Never leave the appliance unattended when it is connected to the
mains.
caution
- For additional protection, we advise you to install a residual current
device (RCD) in the electrical circuit that supplies the bathroom. This
RCD must have a rated residual operating current not higher than
30mA. Ask your installer for advice.
- The barrel and the clip become hot during use. Prevent the hot
surfaces of the appliance from coming into contact with your skin.
- The maximum temperature occurs just after heating up. The actual
temperature during use may be lower.
- Always unplug the appliance after use.
- For safety reasons, the appliance automatically switches off after
having been on for 1 hour.
- Wait until the appliance has cooled down before you store it.
- Always switch off the appliance before you put it down, even if it is
only for a moment.
- Do not leave the barrel in your hair for more than a few seconds at a
time to prevent damage to your hair.
- Always let the appliance cool down on a heat-resistant surface.
EnglisH
7