Krups THE SUB Mode D'emploi page 19

Problem
No beer is being
dispensed.
THE SUB is
dispensing warm
beer.
There is ice in the
cooling chamber.
There is too much
foam.
Possible causes
THE SUB has been switched off. Connect the appliance to the
THE TORP is empty.
There is no TORP inside THE
SUB.
THE SUB tap handle is not
correctly installed/positioned.
There is not enough pressure in
THE TORP.
THE SUB is not connected to
the mains power supply.
The door was not closed
correctly.
The cooling system is defective. Contact the KRUPS customer
The room temperature is below
12°C.
THE SUB has been working too
long with no TORP inside.
The temperature regulation may
be defective.
The beer is not cold enough.
The tap handle was pulled too
slowly during the service.
Remedies
power supply.
Replace THE TORP with a new
one.
Install a TORP inside THE SUB.
Install/position the tap correctly.
Open the door and press THE
TORP backwards THE SUB. You
will then hear the pump running.
1 If the pump is working: it
means there is a problem with
THE TORP. Install a new TORP
in THE SUB.
2 If the pump is not working: it
may be defective. Contact the
KRUPS customer service.
Connect THE SUB to the power
supply.
Close the door correctly.
service.
Install THE SUB in an adapted
environment.
Remove the ice with a warm
sponge and load a TORP inside
the chamber.
Contact the KRUPS customer
service.
Wait until the temperature
indicator changes to green and
then serve the beer.
Pull the handle quickly forward
as far as it will go.
21