Cleaning; Troubleshooting - Krups THE SUB Mode D'emploi

For the other glasses, hold the tap handle in forward position until the glass is filled.
IMPORTANT: If you pull the handle too slowly you will generate extra foam.
You can consult all the information about serving the perfect beer at www.the-sub.com.
CLEANING AFTER DAILY USE
Clean the drip tray (depending on model) and the drip grate after each use.
!
Note: the drip grate (I) can be washed in hot water with a mild detergent (17). It can also
go in the dishwasher. The drip tray (J) (according to models) cannot be cleaned in the
dishwasher.
! Warning! Never use harsh detergents, such as vinegar, acids, solvents or petrol.
CLEANING DURING INSTALLATION OF A NEW TORP
Clean away all traces of beer that have built up on the tap.
The tap mechanism should be cleaned with a damp cloth and some mild detergent (18).
! Warning! Do not attempt to clean the mechanism with hard and/or sharp objects.
Clean the cooling chamber of THE SUB using a soft dry cloth (19).
Problem
THE SUB does not
turn on.
You can not close
the tap cover.
You can not close
the door of THE
SUB.
20

3 - CLEANING

4 - TROUBLESHOOTING

Possible causes
THE SUB is not connected to
the mains power supply.
The electronic board may be
defective.
The tube spout is not inserted
correctly.
THE TORP is not inserted
completely.
Remedies
Connect THE SUB to the power
supply.
Contact the KRUPS customer
service.
Remove the tube spout from
THE SUB and fit it again
following chapter "Installing THE
TORP in THE SUB"
Insert THE TORP in THE SUB
completely.