Setting The Temperature - AEG RA 5656 Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

English

Unpacking the Appliance

1. Remove the appliance from the packaging.

2. Remove all packaging material such as plastic wrap, filler

material, cable ties and cardboard packaging.

3. Check that all supplied parts are included in the box.

NOTE:

There may still be dust or production residues on the ap-

pliance. We recommend that you clean your appliance as

described under "cleaning".

Description of Parts

1 Display

2 MODE button

3 °C/°F button

button

7 Handle

8 Power switch

9 Power cord

10 Castor housing

Assembling the Rollers

CAUTION:

Before the device is used for the first time the rollers have

to be attached.

Please also see our illustration!

• Turn the radiator upside down.

NOTE:

It is best to place a blanket underneath so that the housing

is not damaged.

• Push the 4 castors onto the pins of the castor housing.

• Place the U-shaped brackets between the first and se-

cond and between the last and penultimate fin.

• Insert the ends of the brackets through the holes in the

roller carriers.

• Attach the brackets with the wing nuts.

Instructions

• Unwind the cable completely.

Electrical connection

• Make sure that the appliance voltage (see name plate)

and the line voltage match.

• Switch the power switch to 0.

• Only connect the mains plug to a properly installed

earthed socket.

Connected Wattage

The three power levels of the devices are as follows:

RA 5656

RA 5657

RA 5658

With this connected load a separate supply line protected by

a 16 A household circuit breaker is recommended.

CAUTION Overload:

• If you use extension leads, these should have a cable

cross-section of at least 1.5 mm².

• Do not use any multiple sockets, as this device is too

powerful.

• Do not connect other high power appliances to the

same circuit.

Safety Switch

Your radiator has a safety switch which turns off the electricity

as soon as the device falls over. The safety switch prevents

dangerous situations caused by overheating.

CAUTION:

Always place the device in an upright position in order that

it is stable and in order to prevent malfunctions.

WARNING:

The appliance may still remain hot after it has toppled over.

Wait until it has cooled down.

NOTE:

Switch the appliance on again using the

Levels/Heating Power

1. Switch on the appliance with the power switch.

2. Press the

button

1 X for high power

2 X for medium power

3 X for low power

4 X and the appliance goes to Standby.

NOTE:

• Select low power for e. g. a small room. If this is not

sufficient, switch to the medium or high setting.

• The power settings are shown by (

the display.