Maintenance; Maintenance Regulations - Geberit ECO 203 Mode D'emploi

EN

Maintenance

Maintenance regulations

Pressing tools and pressing attachments that are not maintained, or are not
professionally maintained, can cause serious accidents. You must adhere strictly
to the maintenance intervals and maintenance work described below.
Interval
Regularly (before use, at
the start of the working
day)
Every six months
After 40,000 pressing
operations (interval is
indicated by the red and
green LEDs flashing) or
after two years at the
latest, according to the
information on the test
badge
32
Maintenance work
• Examine the pressing tool and mains cable for
externally visible defects and damage that could
affect safety
• Clean and lubricate the pressing tool
• Clean pressing attachments and check for
defects, particularly for cracks in the material
• Lubricate pressing attachments; see operating
instructions of the relevant pressing attachments
• Have an authorised repair shop perform a test for
safety-related defects or damage. However, this
metrological measurement does not replace any
country-specific regulations and legislation that
might prescribe further checks and maintenance
work
• Have an authorised repair shop check the press
capacity and the state of wear
B1279-001 © 02-2016
966.996.00.0 (00)