Signateur 1500111 Mode D'emploi page 6

4
Use the gas orifice tool to remove the LP orifice from
each main burner valve, through the hole on the
firebox front panel.
Note: All orifices of the grill are double orifices (LP
gas and natural gas). You only remove the LP gas
orifice tip.
6
Use the gas orifice tool to remove the LP orifice from
each main burner valve. Please see zoom-in drawing
that marked with arrow to see where the side burner
valve orifice is located.
Re-install the side burner.
8
Carefully replace each burner, making sure burner
openings slide over valve nozzles and burner holes are
facing up. Re-attach burner hitch pin and cotton pin.
Re-attach any electrodes that we detached in step 3A.
Replace flame tamer,cooking grates and warming rack.
Note: Follow directions in the leak testing section of
this manual before using this grill.
5
5
To allow movement, remove the wing nut from the
side burner. Carefully move burner away from valve
opening.
7
Make sure all control knobs are OFF, then remove all
main and side control knobs
Tighten screw on each control valve as shown.
Replace control knobs when finished.
Note: This screw regulates the low flame setting for
natural gas. After replacing knobs you will notice the
knobs will stop at the " MEDIUM" setting on the
dial. This is the correct low setting for natural gas. Do
not try to turn the knob to " LOW" setting.