Technical Specifications; Bluetooth - PORSCHE DESIGN 911 Mode D'emploi

Problem Possible cause
911 Soundbar turns 1. The ECO function is activated.
itself off.
2. The AUT function is activated.
3. The infrared code for STB has been incorrectly
learned.
911 Soundbar does not 1. The ECO function is deactivated.
turn off automatically.
2. The AUT function is deactivated.
3. The AUT function is activated and the source
device sends a carrier signal even when it is
on standby.
DS_Betriebsanleitung_911_Soundbar_210x148mm_RZ_Teil_1_v19.indd 60-61
Solution
1. Deactivate the ECO function [ see page 51 ].
2. Deactivate the AUT function [ see page 50 ].
3. Relearn the infrared code for STB [ see page 53 ].
1. Activate the ECO function [ see page 51 ].
2. Activate the AUT function [ see page 50 ].
3. Disconnect the source device from the mains or manually
turn off the 911 Soundbar.

TECHNICAL SPECIFICATIONS

Power supply
– Operating voltage 100–240 V
– Operating frequency 50/60 Hz
– Power consumption ECO Standby = 0.39 W [ factory setting ]
– Power consumption AUT Standby = ca. 4.5 W
– Power consumption in idle mode [ no output signal ] = ca. 8.4 W
– Power consumption maximal = ca. 150 W
In-/Output level analogue
– AUX = max. 2.0 V [ effective ]
– SUB OUT = max. 2.0 V [ effective ]
Decoder
– Dolby ® Digital
– PCM [ 32 kHz...96 kHz/8 Bit...24 Bit ]
[ EN ] 911 Soundbar
Virtualiser
– DTS TruSurround

Bluetooth

®
– Bluetooth Standard 3.0 [ A2DP ]
®
– Supports CSR aptX ® decoding
– Range up to 10 m
– Frequency range 2,400–2,483.5 MHz [ 2.4 GHz ISM Band ]
– Max. emitted radiated power 10 mW [ +10 dBm ]
Ambient temperature
– Minimum 5 °C [ 41 °F ]
– Maximum 35 °C [ 95 °F ]
60 | 61
22.09.16 17:48