PORSCHE DESIGN 911 Mode D'emploi page 30

Problem Possible cause
No playback via 1. There is no connection between the
Bluetooth . 911 Soundbar and the end device.
®
2. The end device is paired but no playback
takes place.
3. You are out of range [ max. 10 m ].
The BT input cannot The SEL function is activated [ AUT ].
be selected using the
'Input' keys.
DS_Betriebsanleitung_911_Soundbar_210x148mm_RZ_Teil_1_v19.indd 58-59
Solution
1. Connect your end device as described.
2.1. The end device must be connected again.
2.2. Set the volume on the end device to maximum.
2.3. Increase the volume of the 911 Soundbar.
2.4. Insure that interference sources like a WLAN router or laptop
are not set up in direct proximity of the 911 Soundbar.
2.5. Concurrent operation of WiFi and Bluetooth ® connection from
an end device is not possible without interferences in most
cases [ disable WiFi at your device ].
3. Reduce the distance between the 911 Soundbar and your
end device.
In this case, the switching process happens automatically as
soon as the 911 Soundbar detects an audio signal from the
end device.
Problem Possible cause
1. The preset [ factory setting ] for the AUT function is
The device does not
switch on automatically OFF [ disabled ].
from the optical
2. The device was turned off using the 'ON/Standby'
or coaxial input.
button on your Soundbar remote or the 'Power'
button on your television remote [ Awhen using the
IR learning function ].
3. The device was switched to the other digital input,
which receives no signal and has switched itself off
automatically.
The 911 Soundbar does 1. The SEL function is deactivated [ MAN ].
not switch automatically
2. Bluetooth ® has been deactivated on your
to the BT input.
end device.
3. The 911 Soundbar is connected to a different
end device.
4. The end device is not connected to the
911 Soundbar.
The 911 Soundbar This can happen when your device produces system
switches to the BT input tones, e. g. typing on the keyboard.
inadvertently.
[ EN ] 911 Soundbar
Solution
1. Activate the AUT function [ ON ] [ Page 50 ].
2.1. Turn on the 911 Soundbar using the 'ON/Standby' button on
your remote and wait until it automatically enters standby mode.
2.2. Delete the 'Power' button on your television remote from the
911 Soundbar so that it does not shut off with your television.
3. Switch the device on using the 'Power' key on the remote
control and select the digital input that is connected to the
desired source device.
1. Activate the SEL function [ AUT ].
2. Activate Bluetooth ® on your end device.
3. Deactivate Bluetooth ® on the other end device.
4. Connect your end device to the 911 Soundbar [ Page 49 ].
1. Deactivate the SEL function [ MAN ].
2. Deactivate the system tones on your end device.
58 | 59
22.09.16 17:48