Automatic On/Off Function [ Aut ]; Eco Standby [ Eco ] - PORSCHE DESIGN 911 Mode D'emploi

SET-UP FUNCTIONS

AUTOMATIC ON/OFF FUNCTION [ AUT ]

When this function is activated [ ON ], the device identifies a signal through the optical or coaxial input. When a signal is detected [ e. g. by switching
on the source device ], the 911 Soundbar turns itself on. If no such signal is detected on the selected input [ e. g. when the source device has
been switched off ], the 911 Soundbar will automatically go into AUT standby mode after 30 seconds. When the function is deactivated [ OFF ], the
911 Soundbar needs to be switched on and off manually.
The device is supplied with the function deactivated [ OFF ].
To activate/deactivate this function, proceed with the following steps:
With the device switched on, press and hold the 'Play Mode' key for
1
more than 3 seconds, until appears on the display.
AUT
Press the 'Volume +' key to activate the function [ ON ].
2
Press the 'Volume –' key to deactivate the function [ OFF ].
3
Exit the menu by again pressing and holding the 'Play Mode' key for
4
more than 3 seconds. If no input is given within 10 seconds, the device
will automatically exit the configuration menu.
Comment: The automatic switching on/off function only works for optical and coaxial digital input. If the device is set to standby mode using the
'ON/Standby' key on the remote control, it is not possible for the device to switch on automatically.
The device only identifies a signal at the selected digital input. A signal that appears other than at the selected digital input cannot be detected.
DS_Betriebsanleitung_911_Soundbar_210x148mm_RZ_Teil_1_v19.indd 50-51

ECO STANDBY [ ECO ]

When this function is activated [ ON ], the device automatically goes into standby mode if no signal is detected on the selected input for one hour.
When this function is deactivated [ OFF ], the 911 Soundbar has to be switched off manually.
The device is supplied with this function activated [ ON ].
To activate/deactivate this function, proceed with the following steps:
With the device switched on, press and hold the 'Play Mode' key for more than 3 seconds, until
1
Press the 'Play Mode' key again briefly, until appears on the display.
2 ECO
Press the 'Volume +' key to activate the function [ ON ].
3
Press the 'Volume –' key to deactivate the function [ OFF ].
4
5 Exit the menu by again pressing and holding the 'Play Mode' key for more than 3 seconds. If no input is given within
10 seconds, the device will automatically exit the configuration menu.
Comment: This function is automatically deactivated when using the input TV [ optical ] or DVD [ coaxial ].
[ EN ] 911 Soundbar
appears on the display.
AUT
50 | 51
22.09.16 17:48