Safety instructions
Read and pay close attention to the instructions and
information contained in the operating instructions in
order to ensure safe utilisation.
The Clima Check sensor fulfills the applicable standards of
European and national guidelines and has been constructed
in accordance with state of the art technology. The opera-
ting instructions must be read carefully and observed in order
to ensure safe use. Devices exhibiting any technical defects
must not be used. If there are any doubts with regard to the
operating reliability of the instrument, then it must be retur-
ned to the producer for examination. The determined mea-
surement results and all conclusions are exclusively the
responsibility of the user. No liability is assumed in any case
for any damage which may arise from the use of the equip-
ment or the determined results.
Preventing measurement errors
The Clima Check must always be adjusted to the ambient
temperature or climatic conditions of the environment. Before
starting measurements, the Contact Check sensor and HPM
touch pro must be in the environment to be measured for
approximately 5 min.
Ensure that the measuring sensor is not covered during
the measuring process. For this purpose, hold the Clima Check
using the dedicated handle during measurements.
The determined measurement results and all conclusions
are exclusively the responsibility of the user. We shall not
assume any liability for damage resulting from improper use
of the device.
44