Atag VA7016SRT Mode D'emploi page 42

Settings
7. Rinse aid
8. Super rinse
9. High temperature
10. Water save
11. Water hardness
14
Options
0/1/2/3/4/5/TAB
On/Off
On/Off
On/Off
0/1/2/3/4/5/6/7/8/9
Setting for rinse aid dosage. The rinse aid dispenser can be
adjusted between 0 (Off) and 5 (High dosage).
Increase the rinse aid dosage:
If the dishes have water marks.
Decrease the rinse aid dosage:
If the dishes have a sticky white/blue film.
If the dishes are streaked.
Build-up of foam. If you have very soft water, the rinse aid can
be diluted 50:50 with water.
When using an all-in-one detergent that contains rinse aid, you can
activate the setting TAB.
Super rinse adds two extra rinses.
Activated in the following programmes:
Normal wash
ECO wash
Daily wash
Plastic wash
Lower half wash
Upper half wash
Activate the setting High temperature to improve the dishwashing
results. Energy consumption is slightly increased.
Activated in the following programmes:
Normal wash
ECO wash
Daily wash
Plastic wash
Quick Pro wash
Lower half wash
Upper half wash
Built-in water tank.
Before deactivating the water tank, run a self-cleaning programme.
See Self-cleaning in the chapter Using the dishwasher.
Adjusting the water softener. Read off the appropriate setting from
the water hardness table below.
°dH °fH
0-5 0-9
6-8 10-14
9-11 15-20
12-14 21-25
15-19 26-34
Do not forget to put salt in the salt compartment after you have set
the water softener to 1 - 9.
For a water supply with a hardness under 6°dH (9°fH), select 0.
The water softener is deactivated and no salt is needed.
°dH °fH
20-24 35-43
25-29 44-52
30-39 53-70
40-49 71-88
50+ 89+