Before The First Operation; Safety Cut-Out - Kalorik JK 39825 Mode D'emploi

Fax +32 2 359 95 50

BEFORE THE FIRST OPERATION

For the perfect taste, operate the jug kettle with fresh water in order
to clean any residue left from the manufacturing process. When the
appliance has cooled down, repeat the process 3 times with fresh
water, before rinsing.
OPERATION
Always remove the jug from the power base before filling it or
•
before any operation.
Raise the lid and fill the tank with fresh water paying attention not
•
to fill under the minimum mark or above the maximum mark in
the kettle.
Release the lid and make sure it closes correctly.
•
Put the jug onto the power base, plug into the wall socket and
•
switch on. The pilot light of the switch will come on, indicating
that the appliance is operating. If it does not come on, check if
the kettle is correctly positioned on the base and check if the
base is plugged in.
The jug kettle will switch off automatically when the water has
•
boiled. However, you can stop the appliance any time by putting
the switch in the off position.
For instant reboiling, wait until water has cooled down and switch
•
on the appliance again.

SAFETY CUT-OUT

This jug kettle is protected with an automatic safety device if
•
accidentally switched on without water. Please bear in mind that
only the thermostat is switched off in case of overheat, whereas
the switch stays in ON-position.
In this case, switch off the appliance by putting the switch in OFF
•
position and wait about 10 minutes for the element to cool. Then
pour in sufficient cold water to cover the element. This will reset
the safety device.
The kettle may then be used as normal.
•
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame,
5
Assembly page 5/24
special instruction from Team
Print only
USK JK 39825 - 120501