Important Safeguards - Kalorik JK 39825 Mode D'emploi

Fax +32 2 359 95 50

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should
always be followed, including the following:
1. READ ALL INSTRUCTIONS
2. Check that the voltage in your home corresponds to what is
stated on the appliance.
3. Do not touch hot surfaces. Use handles or knobs.
4. To protect against electrical shock do not immerse cord, plugs, or
the jug kettle in water or other liquid.
5. Close supervision is necessary when any appliance is used by or
near children.
6. Unplug from outlet when not in use and before cleaning. Allow to
cool before putting on or taking off parts.
7. Do not operate any appliance with a damaged cord or plug or
after the appliance malfunctions or has been damaged in any
manner. Return appliance to the nearest authorized service
facility for examination, repair, or adjustment.
8. The use of accessory attachments not recommended by the
appliance manufacturer may cause injuries.
9. Do not use outdoors.
10. Do not let cord hang over edge of table or counter, or touch hot
surfaces.
11. Do not place on or near a hot gas or electric burner, or in a
heated oven.
12. To connect, plug cord into the wall outlet. To disconnect, put the
switch in off position, then remove plug from wall outlet.
13. Do not use appliance for other than intended use.
14. Scalding may occur if the lid of the jug kettle is removed during
the heating cycles.
15. Make sure the appliance never comes into contact with
inflammable materials such as curtains, textiles, etc., when it is in
use, as they might catch fire.
16. When removing lime scale, only use special products for the
removal of lime scale. Never use ammonia or any other
substance that might damage your health.
Copies of the I/B. Please reproduce them without any
changes except under
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame,
2
Assembly page 2/24
special instruction from Team
Print only
USK JK 39825 - 120501