WAGNER AG-19 Mode D'emploi page 20

Gun filter
The AG-19 does not include a pre-mounted gun filter.
i
Depending on the type of material being processed, we
recommend using the appropriate gun filter.
Attention: When processing spray filler and similar materials,
do not use a gun filter as the filter can otherwise become
blocked.
Setup
Never attempt to assemble, change, or clean the gun, tip, or tip
guard without first relieving pressure from the spray system.
Follow the "Pressure Relief Procedure" in the sprayer's
Owner's Manual.
Always use a tip safety guard for added protection against
injection. Beware that the guard alone will not prevent
injection. Never cut off tip guard! Always engage gun trigger
lock when the gun is not in use. Before servicing equipment,
consult Owner's Manuals and follow all warnings.
1. Remove the tip (1) and tip guard (2) from the spray gun.
2. With the tip (9) of the tip lever, insert the tip seal (3) and seal (4) into the
rear side of the tip guard (2) and press hard.
3. Insert the tip (1) into the slot on the tip guard.
4. Thread the tip guard onto the gun. Position the tip guard in the desired
spraying position, then tighten securely.
The arrow on the tip handle should be pointing in the forward
i
direction for spraying.
20
9
2
1
4
3
AG 19
GB