WAGNER AG-19 Mode D'emploi page 21

5. Loosen the fitting (5) with a wrench and pull the filter compartment (6)
and filter (7) out of the gun.
6. Insert the correct gun filter (7) into the filter compartment (6) (narrow
end of filter faces upwards).
7. Place the handle seal (8) into the gun head with the flat side of the seal
toward the gun head.
8. Insert the filter compartment (6) back into the gun and screw it securely
into place.
9. Connect a Wagner original high-pressure hose to the material inlet on the
airless gun. Using two wrenches (one on the gun and one on the hose),
tighten securely.
Before connecting to the airless spray device, check that all parts
of the gun and hose are screwed firmly and securely into position.
AG 19
GB
8
7
Flat side of
handle seal
(toward gun head)
6
5
Bevelled side of
handle seal
(toward handle)
21