Korg C-340 Mode D'emploi page 39

With the finished surface (woodgrain) facing forward, curve (bow) the back panel
3
slightly and fit it into the grooves of the side panel.
Slightly curve the back panel,
and fit it into the grooves
Use screws (b) to fasten the side panels.
4
Start by fastening the bottom edge of the back panel (four locations). In two loca-
tions, pass the screw through a cable holder to attach it to the stand. Attach the
power cable holder at either the right side or the left side depending on the location
of the AC outlet you'll be using.
Then fasten the top edge of the back panel (two locations). Don't tighten these
screws completely yet, since you'll be adjusting this area after you attach the instru-
ment to the stand.
Make sure that the stand is not tilted and that there are no gaps in it, and then firmly
5
tighten all of the screws, except for the two screws you left untightened.
Assembling the stand
Leave untightened
Attach together with
a cable holder
(for the pedal cable)
Finished
surface
Grooves in side panels
Fasten the cable holders
at the left or right side
(for the power cable)
37