Technibel AOF Série Notice D'installation page 20

5.2 - DISCoNNECToR (compulsory for connection to town water)
• K 60 L 110 Z .
GB
5.3 - WATER CoNNECTIoN HoSES
• K 60 L 047 Z: 0.50 m long, female coupling Ø 3/4".
• K 60 L 048 Z: 1 m long, female coupling Ø 3/4".
5.4 - REMoTE CoNTRoL
A - Mounting / Installation
• See the main characteristics in the Technical Instructions.
• Consult the "Installation instructions" supplied with the control.
• The unit is connected using 0.75 mm
• The cables used must comply with the insulation requirements for the voltage used (230 V).
• This information relates above all to the sensor input of the automatic control connected to the 230 V supply.
• The temperature adjustment range can be limited by means of the mechanical limit stops located on the control knob.
Wall mounting:
• Secure the unit at a height of approximately 1.5 m from the floor in a location representative of normal convection currents,
while avoiding:
- Wall which are poorly insulated or liable to vibrate.
- The proximity of parasitic heat sources (sunshine, heating appliances, lamps, fireplaces, televisions, etc.).
- Currents of air from doors or windows.
- Sheltered locations such as shelves or behind curtains.
- Near electrical outlets.
• For manual control K 60 D 076 Z, check and modify as required the ventilation selection jumper connection SR depending
on the appliance (see below).
• For the K 60 D 025 Z automatic control, if necessary, adjust the neutral zone using the potentiometer located inside the
control.
Wiring instructions on device:
• Run the cable alone with the water pipes or through the cable cross panel provided on the left side of the cabinet.
• And run it through a rubber cross panel to the control box. To do so, first remove the control box casing.
• Connect the wires to the terminal block according to electrical diagram of each case.
B - Connections with RAB 30 or RAB 31 manual remote control - Code K 60 D 076 Z
Operating switch
with fan speed selection
Temperature setting knob
Heating / cooling
selector switch
2 cable (minimum) (1.5 mm 2
Position of the SR bridge located inside the controller:
- on SR1
- on SR2 (Auto) = Ventilation activated when the thermostat is
8
max.).
K 60 D 076 Z
SR
L
SR1
Auto
Q3
SR2
Q2
Q1
Y2
Y1
= Permanent ventilation.
in demand.
This position is not accessible with a
heating kit.
AO
Phase
L
Neutral
N
HS
1
MS
2
LS
3
4 Cooling
Heating
5