Technibel AOF Série Notice D'installation page 18

3.4 - MouNTING
• The device must be installed in vertical position and level. It must
always be installed fastened (to the floor or on a wall mounting).
GB
• For assembly on a wall mounting, refer to the accessories chapter for
the mounting to be used.
• For secure fastening, it can be fastened to a wall using the screws and
pins supplied with the device (2 fastening holes on the rear mounting).
• It must be obligatorily fitted flush against a wall in all cases.
• To prevent the transmission of vibrations to the floor, you are
recommended to put rubber blocks under the unit.
• These 4 supplied blocks are to be put by the 4 pressings acting as feet,
as indicated opposite.
• The unit is raised by 5 mm.
3.5 - CHooSING THE BLoWING DIRECTIoN
3.5.1 - STANDARD DELIVERY
• Vertical backward blowing.
3.5.2 - FoRWARD BLoWING
• Turn the grille 180° (see dismantling below).
3.5.3 - HoRIZoNTAL BLoWING
• Remove the cabinet (see page 5).
1 - Remove the outlet grille (1): undo the two clips (A) by turning
them a quarter of a turn (using a screw driver or a coin).
2 - Remove the door (9) by pressing on the side to release the
hinge pin (B).
3 - Remove the control panel (7) by taking out the two fastening screws (C).
4 - Remove the removable panel (2) by taking out the four fastening screws (D).
5 - Refit the removable panel (2) on the top and fix it with the four screws (D).
6 - Refit the control panel (7) on the front part and fix it with the two screws (C).
7 - Refit the door (9) by pressing on the side to engage the hinge pin (B) in the hole.
Refit the outlet grille (1) and lock the two clips (A) by turning them a quarter of a turn.
8 - Remove the control box casing.
9 - Take out the control panel held by two screws.
10 - Position the control panel by turning it 90° towards the front. Fix with the 2 screws.
A
1
D
4
8
1 A
2
D
2 5
9
Pressings
acting as
Rubber
Backward blowing
B
B
9
2
D
D
6
feet
block
Rubber
block
Forward blowing
C
3
C
6
C
B
A
A
7
B
1
10
Adhesive
side
7
7
9