Mitsubishi Electric CITY MULTI PAC-PH01EHY-E Manuel D'installation page 6

6
XL-module
[Fig. 6.2.1]
[Fig. 6.2.2]
A
[Fig. 6.2.3]
*C
D
6
<B>
<A> Remove the front panel from the unit by unscrewing the 14 screws.
<B> Remove the fan guard by unscrewing the 12 screws.
* Remove the snow protection hood (optional parts), if any.
<A>
<A>
<A> Remove the control box front cover by unscrewing the five screws.
A Control box front cover
<A>
A
B
A
<B>
6.2
A
<A> Remove the external temperature sensor wiring from the left
drain pan by cutting the two cable ties.
<B> Unhook the pipe cover from the left drain pan.
<C> Remove the left drain pan by unscrewing the two screws.
A Left drain pan
B External temperature sensor wiring
C Cable tie
D Pipe cover
* When re-placing B to the left drain pan after installing the panel
heater, use the supplied cable tie (100 mm).
<C>