Mitsubishi Electric CITY MULTI PAC-PH01EHY-E Manuel D'installation page 15

8
XL-module
[Fig. 8.1.2.3]
A
Right side
[Fig. 8.1.2.4]
A
<A>
<A> Pull up the panel heater wirings so that the wirings run along the right rear pillar.
<B> Run the panel heater wirings between the right rear pillar and the heat exchanger.
<C> Attach the rubber sheet to the right frame so that the heat exchanger fin will be
covered. (Using the wiring access hole and the tab on the frame as a reference
position)
<D> Pull the wiring through the hole on the right frame and into the inner side of the
heat exchanger.
A Panel heater wiring
B Right rear pillar
C Right frame
D Plate rubber XL
E Wire seal
* If the frame is not painted, place the supplied wire seal
around the hole.
A
<A> Screw down the metal sheet wiring cover at three points.
A Cover wiring 1
<A>
B Cover wiring 3
B
8.1.2
B
*C
A
<B>
D
<C, D>
Hole
Tab
E
15