Rowenta DW4000 Mode D'emploi page 19

1103906211 DW4000:110x220
If there is a problem?
PROBLEM
Water drips from You are using steam while
the holes in the the iron is not hot enough.
soleplate.
You are using the Shot of
Steam button too often.
You have stored the iron
horizontally, without
emptying it and without
setting it to
Brown streaks You are using chemical
come through descaling agents.
the holes in the
soleplate and
You are not using the right
stain the linen.
type of water.
Your linen has not been
rinsed sufficiently or you
have ironed a new garment
before washing it.
The soleplate is Your are ironing with an
dirty or brown inappropriate temperature
and can stain the selection (temperature too
linen. high).
You are using starch.
There is little or The water tank is empty.
no steam.
Your iron has been used
dry for too long.
The soleplate is You have placed your iron
scratched or flat on a metallic rest-plate
damaged. or ironed over a zip.
Steam or water The steam control is not set
come from the to the
iron as you finish
The water tank is overfilled.
filling the tank.
The spray does The water tank is not filled
not spray. enough.
Environnement
Environment protection first !
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
6/11/09 10:48
POSSIBLE CAUSE
Wait until the thermostat light
goes out.
Wait a few seconds between
each use of the button.
See the section "Storing your
iron".
.
Do not add any descaling
agents to the water in the
water tank.
Perform a self-cleaning
operation and consult the
chapter "What water should I
use?".
Make sure that your laundry is
rinsed sufficiently in order to
remove any deposits of soap or
chemical products on new
clothes.
Clean the soleplate as
indicated above. Select the
appropriate program.
Clean the soleplate as
indicated above. Always spray
starch onto the reverse side of
the fabric to be ironed.
Fill the water tank.
Carry out a self-clean.
Always set your iron on its
heel.
Do not iron over zips.
Check that the steam control is
position. set to the
Never exceed the Max level.
Fill up the water tank.
18
Page 18
FR
SOLUTION
NL
DE
EN
IT
ES
PT
EL
TR
DA
SV
NO
FI
HR
SR
BG
SL
PL
position.
CS
SK
HU
RU
UK
RO
ET
LV
LT
AR