Installation; Ambient Temperature; Power Failure; Temperature Control - Proline PLCH104 Manuel D'instructions

BEFORE INSTALLING THE FREEZER
Before connecting your appliance to the power supply, check that the voltage stated on the rating label of your appliance corresponds to the voltage in your
home. A different voltage could damage the appliance.
The plug is the only way to unplug the appliance and should therefore be accessible at all times. To turn off main power to the appliance, turn it off and then
detach the plug from the outlet. Do not immerse the appliance, the power cord or the plug in water or other liquid.
The appliance must be grounded. The manufacturer is not responsible for damages that may occur as a result of usage without grounding.

INSTALLATION

Install the appliance in a dry, well ventilated room. The installation location should neither be exposed to direct sunlight nor near a heat source, e.g. a cooker,
radiator, etc.
To ensure adequate ventilation for the appliance, allow a minimum of 10 cm of airspace on each side of the cabinet.
For uneven surfaces, two feet can be aligned.

AMBIENT TEMPERATURE

This appliance is designed to operate in ambient temperature from 10°C to 43°C. If these temperatures are exceeded, i.e. colder or warmer, the appliance will
not operate correctly. If the ambient temperatures are exceeded for long periods, the temperature in the freezer will rise above -18°C and food spoilage may
occur.
BEFORE PLACING FOOD IN THE FREEZER
Remove all packaging.
Allow the appliance to run empty for 2 – 3 hours so it can cool to the appropriate temperature.
Clean the inside of the appliance with warm water and a little liquid detergent to remove manufacturing and transportation dust.

POWER FAILURE

If there is a power failure, do not open the door. Frozen food should not be affected if the power failure lasts for less than 24 hours.
Do not refreeze frozen foods that have thawed completely. The food may be dangerous to eat.

TEMPERATURE CONTROL

The appliance is controlled with a temperature control knob located on its outside wall.
Adjust the control knob as desired to suit your individual preference.
1. Plug the freezer in the mains socket.
The power indicator light will illuminate.
2. Adjust the temperature control knob to the desired position between MIN (cold) and MAX
(coldest).
3. OFF is off setting – The appliance will stop working.
NOTE: When you use the appliance for the first time or after defrosting, adjust the control knob to
the coldest setting for at least 2 hours before introducing food to be stored, and then readjust to
the middle setting.

MOVING YOUR APPLIANCE

If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This will allow the refrigeration system pressures to equalise before
restarting.
Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove all mobile parts (basket, accessories, etc.) or fix them into the
appliance to avoid any shock.
Relocate and install. If the appliance has been left on its side for any length of time, leave it standing upright for at least 10 minutes before turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally friendly and natural gas, it is explosive. Therefore you should be
careful during shipment and installation to prevent your appliance's cooler elements from being damaged. In the event of a leak caused by damage to the cooler
elements, move your appliance from open flame or heat sources and ventilate the room where the appliance is located for a few minutes.
5
EN