Haier HRF-628A 6 Série Mode D'emploi page 24

Problem
3.3 Water forms at underside of the
crisper glass covers.
Water/humidity/frost on the outside of the fridge
4.1 Wet air forms droplets of water
on the outside edges of the
fridge.
Automatic Ice maker
5.1 The ice maker does not work
properly.
5.2 Ice cubes are too large or too
small.
Cold water & ice dispenser
6.1 Cold water not dispensing.
6.2 The water has a strange odour. 6.2.1
6.3 Ice not dispensing.
6.4 Dispenser is jammed
Cause
3.3.1
foods.
3.3.2 Door seal leaks or frequent
door openings in humid
environment.
4.1.1 Warm, humid air in the
environment mixes with
cooler air at the door gasket
areas of the fresh food
and freezer compartments
causing condensation.
5.1.1 Ice cubes are sticking
together.
5.1.2 Ice cubes may end up
sticking together if stored
too long.
5.2.1 Ice maker water supply set
incorrectly.
6.1.1 The freezer or refrigerator
door is not fully closed.
The water supply pipe is not
open.
6.1.2
6.1.3 The water line is blocked.
The water has been stored
too long without use.
6.2.2 The local potable water
source is suspect.
6.3.1 The freezer or refrigerator
door is not fully closed.
6.3.2 No ice cubes in the container 6.3.2.1
6.3.3 Freezer temperature set too
high.
6.4.1 Defrosting water has frozen
on the spindle.
6.4.2 Ice cubes are jammed
between the ice maker and
container.
6.4.3 Ice cubes are sticking
together.
6.4.4 Other ice cubes were placed
in the dispenser.
21
Solution
3.3.1.1
with a dry cloth to remove excess moisture.
3.3.2.1 Check the door gaskets and reduce door
openings. Possibly raise fresh food temperature.
4.1.1.1 A small amount of dew or water moisture is
normal. It is best to wipe it down with a dry
cloth to improve performance.
4.1.1.2 A slight increase in the compartment
temperatures can reduce this moisture
formation.
4.1.1.3 Check door gasket for proper seal and clean.
5.1.1.1 Take out the lump of ice cubes, crush it and then
return only the separated ice cubes back to the
ice cube container.
5.1.2.1 See 5.1.1.1 above.
5.2.1.1 Adjust the ice maker water supply.
6.1.1.1 Close all appliance doors.
Open the water supply line all the way.
6.1.2.1
6.1.3.1 Check that the water tubes are not kinked or
restricted.
6.2.1.1 Remove 7 cups of water and throw away.
Check if the odour improves.
6.2.1.2 Contact your local water supply company to
check quality of the water.
6.3.1.1 Close all appliance doors.
Wait until ice cubes are supplied.
6.3.3.1 Lower the freezer temperature to improve the
ice cube maker performance.
6.4.1.1 Remove the container. Clean and dry the
spindle. Replace the container.
6.4.2.1 Remove the ice cubes between the ice maker
and container.
6.4.3.1 Take out the lump of ice cubes, crush it and then
return only the separated ice cubes back to the
ice cube container.
6.4.4.1 Only ice cubes produced by the ice maker can
be used in the dispenser.