Removing And Installing The Doors; Refitting The Door - Haier HRF-628A 6 Série Mode D'emploi

Fig.4-4
Fig.4-5
Hinge cover
Fig.4-6
Fig.4-7
Fig.4-8

Removing and Installing the Doors

Unscrew the 2 screws holding the toe moulding in position
and remove (Fig.4-3).
Release the water coupler: press and hold in the collar as
shown (Fig.4-4) and remove the water pipe.
Remove the top cap.
The Freezer Door
1.
2.
3.
The Fridge Door
1.
2.
3.
Refitting the Door
Hinge cover
16
In the event that you need to remove the
!
refrigerator doors, please follow the door removal
and installation instructions below.
It is suggested, for your safety, to have two or more
!
people to assist you in completing the below task to
avoid injury, product damage or property loss.
Undo the hinge cover screw and remove the cover
(Fig.4-5). Disconnect all wires except for the grounding
wire.
Undo the screws holding the upper hinge in position
and then remove the hinge (Fig.4-6).
Lift the freezer compartment door to remove it. Next, lift
the door enough to be able fully pull the water line out
from the bottom.
Undo the hinge cover screws and remove the cover
(Fig.4-7). Disconnect all wires except for the grounding
wire.
Undo the screws holding the upper hinge in position
and then remove the hinge (Fig.4-8).
Lift the refrigerator compartment door to remove it.