Cleaning, Care & Maintenance - Vogue GD232 Mode D'emploi

UK
Sharpening Stage 1
Use for blades with a very blunt edge.
1. Connect the sharpener to the mains power
supply.
2. Turn the power switch to 'I'.
3. Hold the handle of the knife firmly and place
the blade hilt in the left sharpening slot of
Stage 1.
4. Apply enough pressure for the knife to make
contact with the sharpening wheel.
5. Pull the blade back to the tip in a smooth
motion. Do not twist or rock the blade.
6. Repeat this process for the right sharpening
slot of Stage 1.
Cleaning, Care & Maintenance
• Always turn off and disconnect the appliance from the power supply before cleaning.
• Use soapy water and a damp cloth to clean the exterior of the appliance.
• Remove the sharpening head by turning clockwise. The covers of the sharpening wheels (1 & 2) can
be removed by pushing the cover in at one end and lifting. Filings can then be emptied. Afterwards,
assemble the appliance in the reverse order.
4
GD232_ML_A5_v2_20201202.indb 4 GD232_ML_A5_v2_20201202.indb 4
Note: As a guide, each pull for a 6 inch
blade should take 2-3 seconds. An 8 inch
blade should take 4 seconds and longer
blades 6+ seconds.
Sharpening Stage 2
Use for honing a blade or to achieve a razor sharp
edge after stage 1.
• Repeat steps 3-6 as above, using Sharpening
Stage 2.
Note: 1-2 pulls on each side of
stage 2 is normally sufficient,
though more pulls will achieve a
finer edge.
1
2
2020/12/2 13:59 2020/12/2 13:59