Quick HECTOR HC 712 Manuel De L'utilisateur page 11

BEFORE USING THE WINDLASS READ THESE INSTRUCTIONS CAREFULLY.
IF IN DOUBT, CONTACT YOUR NEAREST "QUICK
WARNING:
the Quick
®
ses. Quick shall not be held responsible for damage to equipment and/or personal injury, caused by a faulty use
of the equipment.
ms). Always deactivate the windlass when not in use.
Check that there are no swimmers nearby before dropping anchor.
use a three-strand rope and make an effective splice, seeking expert advice if necessary.
For improved safety we recommend installing at least two anchor windlass controls in case one is accidentally
damaged. We recommend the use of the Quick
Secure the chain with a further device before starting the navigation.
THE PACKAGE CONTAINS:
TOOLS REQUIRED FOR INSTALLATION:
mill; hexagonal wrenches: 13 mm and 17 mm.
"QUICK ® "ACCESSORIES RECOMMENDED:
(mod. HRC1002) - Foot switch (mod. 900) - Hydraulic-magnetic circuit breaker - Anchor chain counter (mod. CHC1102M and
CHC1202M) - Radio control (mod. 1302,1352; 02, 302).
INSTALLATION REQUIREMENTS:
the upper and lower surfaces of the deck are as parallel as possible. If this is not the case, compensate the difference appro-
priately (a lack of parallelism could result in a loss of motor power). The deck thickness must be included among the figures
listed in the table. In cases of other thicknesses it is necessary to consult a Quick
deck to the passage of cables, rope and chain; lack of depth of the peak could cause jamming.
FITTING PROCEDURE:
move excess material from the chain through hole, ensuring the free passage of the chain or rope. Screw the stud bolts, using
the short threaded end, onto the base. Apply a medium grade locking product onto the thread. Position the windlass lowering it
from above deck. Fix the windlass by screwing the nuts onto the fixing studs. For an improved watertight seal it is advisable to
apply silicone around the entire outside edge of the base. Connect the supply cables from the windlass to the battery.
C
B
A
WARNING:
before wiring up, be sure the electrical cables are not live.
HECTOR 700/1000/1500W - REV003E
® windlasses are designed to weigh the anchor.
The windlass is not designed for the loads that might occur in extreme weather conditions (stor-
windlass - handle - bolts and screws (for assembly) - user's manual - warranty card.
drill and drill bits: Ø 11 mm (7/16") - Ø 24 mm (15/16") and Ø 43 (1" 11/16) hollow
the windlass must be positioned with the gypsy aligned with the bow roller. Ensure that
max 5 mm
(3/16")
When the ideal position has been established, drill four holes using the drilling template provided. Re-
45°
® " DEALER
® hydraulic-magnetic switch as the motor safety switch.
anchoring RL control board (mod. 800) - Waterproof hand helds R/C
40 cm
(16")
INSTALLATION
.
Do not use the equipment for other purpo-
For mixed rope-chain installation always
® retailer. There must be no obstacles under
GB
11