Defects, Reasons - Haas+Sohn RLU-CDIN 18897 Mode D'emploi

7. Defects, reasons

Defect:
Der Ofen heizt schlecht oder
raucht:
The fuel is burning too fast:
The glass of the door gets soiled
quickly:
The door glass has milky colour
Bothering smoke:
8
Reason:
The draft of the chimney is too low
(min. 10 Pa. in the neck of com-
bustion products)
The stove or the smoke flue tubes
are clogged with soot
The connection tube of the stove
to the chimney is not tight
The amount of fuel in the stove is
excessive
The stove has not been con-
nected properly, or the chimney is
overcharged
The input of external air is missing
Bad weather conditions (transition
seasons)
Too large wood logs
Appliance not tight (sealing of the
door, of the glass)
The draft of the chimney too big
(min. 20 Pa. in the neck of com-
bustion products)
Wet wood stock
Too large wood logs
The draft of the chimney is too low
(min. 10 Pa. in the neck of com-
bustion products)
Air slider for ignition open Position
"ON"
The draft of the chimney too big
(min. 20 Pa. in the neck of com-
bustion products)
Overheating
The fuel has not burned down
completely
Suppression:
Seal the chimney cleaning orifices
that are not tight.
Have the draft of the chimney
measured by the chimneysweep
in charge.
The stove and the smoke flue
tubes are to be cleaned in time
Check the connection tube and
seal it
Use the amount of fuel as per the
specification
Consult the chimneysweep
Day-to-day shock ventilation
Set up the lever of air control to
"Ignition".
Use smaller logs (max. 0.7 kg/
piece)
Replace the sealing
Have a draft limiter installed
Check up, max. 17 % of residual
moisture
Use smaller logs (max. 0,7 kg/
piece)
Seal the chimney cleaning orifices
that are not tight.
Have the draft of the chimney
measured by the chimneysweep
in charge.
When the fuel starts burning lively,
set the slider for ignition to the po-
sition "Heating operation
regime"
Have a draft limiter installed
New glass
Stoke new fuel on live embers on-
ly (no flame)