Unsuitable Fuels; First Putting In Operation; Ignition; Ignition With The Air Control Easy Control - Haas+Sohn RLU-CDIN 18897 Mode D'emploi

1kg of wood briquettes = about 5kW
Note
Wood briquettes expand during combustion, and therefore, they ought to be broken to pieces.

5.2. Unsuitable fuels

Never use for heating any waste, wallpapers, rests of chipboards, plastics or impregnated wood! When
combusting such materials, the appliance can suffer damage, by the consequence of which any guarantee
ceases to exist.

5.3. First putting in operation

Prior to first putting in operation, it is necessary
• To remove stickers, if there are any.
• To take out all accessories from the ash-pan or from the combustion space.
• Check whether the return draft boards (see the specification of the appliance – spare part combustion
space, figure A) are mounted in their embeddings. These can shift during the transport or installation of the
fireplace stove.
CAUTION
During the first putting in operation, a stench can be produced for a short time. Please provide for this time
sufficient ventilation of the room where the stove has been installed, and avert direct inhalation.

5.4. Ignition

5.4.1. Ignition with the air control EASY CONTROL

• First of all, lay logs according to their size (about 1.5 – 2.0 kg) on the bottom of the combustion space or on
the grate, lay on them a block of solid fire-brand, and on the top, sufficient amount of kindling chip (for
ignition). The indicated amount of wood refers to the first ignition ONLY.
• The lever must be set up to "Ignition "ON". After the ignition, the door of the combustion chamber is to be
closed.
• The course of ignition depends on the draft of the chimney. As soon as complete fuel starts burning lively,
the lever is to be re-set to "Heating operation regime".
Ignition Heating Closed input of air
5