Getting Started; Power Connection - Beem B27.001 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN

Getting started

Unpacking
Proceed as follows:
1. Take the appliance, all accessories
and the user manual out of the box.
2. Remove all packaging material and
protective films from the appliance and
the accessories before using them for
the first time. Do not remove the type
plate or any warning notices.
If possible, keep the original packag-
ing for the duration of the appliance's
warranty period so that the appliance
can be packaged properly in the event
of a warranty claim. Shipping damage
voids the warranty.
Checking the scope of supply
Proceed as follows:
1. Check the contents for completeness
and visible damage. Do not operate a
damaged appliance.
2. Notify your supplier promptly in case
of an incomplete or damaged delivery.

Power connection

The following regulations for the electrical
supply must be observed to ensure safe
and trouble-free operation of the appli-
ance:
1. Be certain that the appliance can be
connected to a properly installed pro-
tective conductor electrical system.
Operation using a socket without an
earth conductor is not permitted. If in
doubt, have the house mains network
inspected by an electrician. The man-
ufacturer assumes no responsibility
for damage resulting from the absence
or interruption of a protective earth
conductor.
BEEM – Elements of Lifestyle
2. Before connecting the appliance,
compare the electrical data (voltage
and frequency) on the type plate with
that of your electrical mains network.
These data must match to avoid
damage to the appliance. If in doubt,
ask your electrical appliance retailer.
3. Be certain that the socket is protected
by at least a 10 A automatic circuit
breaker.
4. Be certain that the power supply cord
is not damaged. Route the power
supply cord in such a way that it poses
no risk of stumbling. The power supply
cord may not be routed over sharp
edges and may not be pulled taut or
kinked. The power supply cord must
not come into contact with hot sur-
faces.
Before first use
1. Clean the appliance and the accesso-
ries as described in the chapter
Cleaning and care (page 20).
Party Platte 4 in 1
17

Publicité

Table des Matières
loading

Table des Matières